How to Solve the HP Printer Error Code 89

The error is referred to as a PostScript (ROM) failure in the printer. The likely cause of the error would be that the ROM in the printer may have gone bad due to a damaged pin and maybe finding it incorrectly.

Steps to solve HP Printer Error 89:

Solution 1:

• First of all, make sure that the ROM is properly placed in the printer.

• When the problem occurs, try turning off the computer and printer for a while.

• After a while start it again; Even if the problem recurs, the ROM hardware is probably broken, and a new one is needed.

Solution 2:

If the first step doesn't work, try this method; You will need to check the pins as there is a high chance that the pins could be damaged and broken, so try to regenerate the nails and adequately reset and restart the printer.

Solution 3:

• As you know, the problem is with the printer, so the important thing here is that the printer needs a power cycle.

• Now, you have to delete all the papers which are kept in the printer.

• You must now do the restart task; That is, you need to carefully turn off the power button and detach the cable from the connector.

• After waiting a few minutes, place the cable with the connector on and switch on the Power button to turn the printer online.

• Now, a motor-diagnostic test needs to be done to determine the problem in the printer.

• Also, it would be better if you make sure that the motor is not damaged and is properly connected to the engine.

• After doing the above, you need to replace the motor carefully.

It is necessary to check whether the ROM is in good condition; the above solutions are done if it is in working condition and these results in the solution of the HP Printer Error 0xc18a0206 at times. But, if the ROM is in bad condition, the above solutions will not work, and the best way to fix it would be to replace the ROM hardware by contacting the printer's professional executives. I hope this helps!