The Xbox 360 is already an amazing package in itself. However, with games like Call of Duty 5, Modern Warfare, and Modern Warfare 2, more and more people find reasons to modify the said game console, or its accessories. One such modification is just https://www.BestXboxonecontrollers.com a response to produce a rapid fire modded Xbox 360 controller. Here will be the steps on the best way to modify your original controller to a rapid fire controller.
Step 1. Unscrewing the controller
Before you start taking your controller apart, have a close look at the controller first and try to consider which parts go where because you will eventually have to put everything back again. Begin by unscrewing all of the visible screws at the back. After this, when you tug on the case, remove the batteries to reveal the hidden screws. Remove these as well.
Step 2. Preparing the Case
With the controller facing down, slowly and carefully separate leading half the casing from the circuit board. A hole in the case will ultimately have to be made. Remember this before putting things back.
Step 3. Placing The Rapid Fire Button
While other ways of modifying the controller do not involve installation of a fresh button, this particular guide does. Not just does this ensure it is easier to regulate the rate of rapid fire, it minimizes tampering with the rest of the circuit board, thereby minimizing the risk of damaging your modded Xbox 360 controller.
Remember, kits for the rapid fire controller are available easily. It is the button using this kit that'll be placed through the hole in the casing, so put it gently prior to the circuit board is returned. You might have to snip out a few flaps to produce way for the wires of the kit. This can be carried out with whether cutter or a set of scissors.
Step 4. Soldering
Let's assume that you understand how to properly utilize a soldering iron, attach the red wire to the leftmost pin of a 4-pin horizontal series, as the blue wire solders to the rightmost pin of the exact same series. The black (or green in some cases) wire attaches to the middle of the three vertical series to the right of the switch.
Soldering is probably the most crucial step to making the modded Xbox 360 controller. This is because mistakes made during this stage can permanently damage your controller.
Step 5. Putting everything back
Carefully taking note of the wires, make an effort to close the circuit board and the casing. This can be only a little tricky because the newest wires are certain to get in the manner of things. Find a method for these wires to occupy the empty spaces in place of sticking out. You could support the modded Xbox 360 controller facedown so that the buttons don't fall and maneuvering the wires are a little easier. Put the casings together but don't return the screws yet.
At this time you will need to check on if the rapid fire buttons work. If they do not, you may want to restart both your console and the now modded Xbox 360 controller. This will solve the problem. When it doesn't then you may want to go through the steps again to double check.